Tips to Install Water Heater Vent

For one to learn how to install a water heater vent, you will need a hacksaw, rags, wire brush, carpenter’s level, adjustable wrenches, tubing cutter, a propane torch and a screwdriver. The hot water vent also needs a constant gas supply, an outlet for the harmful emission and a cold water supply. Before installation, ensure your home has sufficient ventilation.

 

Step 1:

 

Cut off the supply of both water and gas before fixing a hose pipe to drain the valve and empty the tank’s content before turning on the hot water inlet for air suction into the system. This should be done prior to disconnecting the gas and water line.

 

Step 2:

 

Separate the gas exhaust from the outlet to allow set up for the new heater. Set up involves leaving room for ventilation and reconnection of the harmful gases outlet and exhaust vent.

 

Step 3:

 

Proceed to fix the heat trap fittings for cold water and hot water inlet and outlets, followed by water supply connections.

 

Step 4:

 

Attach the gas supply to pre cleaned valves for the safety of the system. This step also includes getting rid of the air trapped in the valves and faucets. Once the gas line is fixed, turn on the gas supply first then the water supply. Watch out for any leaks both in the gas and water lines and fix them promptly.

 

Step 5:

 

A test run is in order, to see how well the installation works out. Ignite the burner for initial testing; if there’s no sound, repeat the test run while following the instructions keenly until all is in order. Finally, set the temperature and proceed to enjoy your bath.

 
The good thing about the vented water heaters is that they cost half as much to maintain as compared to natural-draft water heaters. Use these easy steps on how to install water heater vent and start enjoying the benefits.